HP Z210 HP Z210 Workstation Series User Guide - Page 26

then reinstall them see

Get HP Z210 PDF manuals and user guides View all HP Z210 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 26 highlights

6. On the back of the front bezel, squeeze the HP logo mounting tabs (1) and press the logo outward (2) as shown in the following figure. Figure 3-6 Rotating the HP logo Rotate the HP logo 90 degrees counterclockwise, and then release the logo and press it back into place in the front bezel. 7. Remove the EMI filler panels and remove the optical disk drive from the chassis. 8. Rotate the EMI filler panels and the optical drive 90 degrees as shown in the figure below, and then reinstall them (see Installing an optical drive (desktop configuration) on page 55. Figure 3-7 Reinstalling the optical drive 9. Replace the front bezel and the side access panel when finished. 18 Chapter 3 Setting up the workstation ENWW

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
6.
On the back of the front bezel, squeeze the HP logo mounting tabs (1) and press the logo outward
(2) as shown in the following figure.
Figure 3-6
Rotating the HP logo
Rotate the HP logo 90 degrees counterclockwise, and then release the logo and press it back into
place in the front bezel.
7.
Remove the EMI filler panels and remove the optical disk drive from the chassis.
8.
Rotate the EMI filler panels and the optical drive 90 degrees as shown in the figure below, and
then reinstall them (see
Installing an optical drive (desktop configuration)
on page
55
.
Figure 3-7
Reinstalling the optical drive
9.
Replace the front bezel and the side access panel when finished.
18
Chapter 3
Setting up the workstation
ENWW