HP Z800 HP Z800 Workstation Maintenance and Service Guide - Page 110
free up a SATA data port connector on the system board.
UPC - 884962082454
View all HP Z800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
6. Connect the power and data 2 cables to the drive as shown in the following figure. Figure 5-27 Connecting power and data cables 7. Connect the optical disk drive data cable to the next available SATA port on the system board as shown in the following figure. Figure 5-28 Connecting the drive cable to the system board NOTE: If no SATA data port connector is available on the system board, check to see that all attached SATA cables are connected to active devices. An unused device can be disconnected to free up a SATA data port connector on the system board. If no SATA data port connector is available on the system board, move the attached SATA storage device data cables to the next available SAS data port connectors on the system board. See Component locationson page 71 for connector locations on the system board. 98 Chapter 5 Replacing components ENWW