HP Z800 HP Z800 Workstation Maintenance and Service Guide - Page 162
It is normal for the expansion card retention clamp to have a slight 5-10 degree angle
UPC - 884962082454
View all HP Z800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 162 highlights
7. Angle the card into the PCI card guide. Align the PCIe card keyway with the slot key, and then firmly seat the card in the slot as shown in the following figure . If required by the card, connect the auxiliary power cable to the card (not illustrated), or other cables or accessories described in the card instructions. (See Removing the expansion card guide/front fan holder on page 127 to find the storage location of the auxiliary power cables.) Figure 5-96 Installing a PCIe card 8. Close the expansion card retention clamp by rotating it downward 2. The retention clamp is secured by the expansion card support. NOTE: It is normal for the expansion card retention clamp to have a slight (5-10 degree) angle when closed. If the angle is greater than this, open the clamp and ensure that all cards are properly seated and all the brackets are mated to the chassis, then re-close the clamp. 9. Install the expansion card support (see Installing the expansion card support on page 80). 10. Reinstall all removed components and reconnect any cables that have been disconnected. 150 Chapter 5 Replacing components ENWW