HP Z800 HP Z800 Workstation Maintenance and Service Guide - Page 142
Installing the expansion card guide/front fan holder, To engage the hooks
UPC - 884962082454
View all HP Z800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
Installing the expansion card guide/front fan holder 1. Ensure that the fan holder includes the desired cooling fans (see Installing a second front system fan on page 133). 2. With power off to the workstation and the chassis open, place the expansion card guide/front fan holder assembly in the chassis. Place the tabs at the bottom of the assembly into the slots in the chassis as shown in the following figure . NOTE: When positioning the expansion card guide/front fan holder into the chassis, make sure there are no cables between the fans and the chassis mounting wall. All workstation cables should be located under the card guide. TIP: To engage the hooks, you might have to press down firmly on the card guide/fan holder to overcome cable resistance. 3. Rotate the assembly up until it snaps into place 2 4. Connect the cooling fan power cables to the system board (see Installing a second front system fan on page 133). 5. Reinstall all removed components and reconnect any cables that have been disconnected. 130 Chapter 5 Replacing components ENWW