HP Z800 HP Z800 Workstation Maintenance and Service Guide - Page 136
Installing dual SFF hard drives in the optical drive bay, Installing the hard drives,
UPC - 884962082454
View all HP Z800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 136 highlights
Installing dual SFF hard drives in the optical drive bay This section describes how to install two small form factor (SFF) hard drives in the workstation optical drive bay, and how to connect the hard drive cables. Installing the hard drives 1. Disconnect power from the workstation (see Predisassembly procedures on page 74). 2. Remove the side access panel (see Removing the side access panel on page 76). 3. Remove the airflow guide (see Removing the airflow guide on page 77). 4. Remove the expansion card support (see Removing the expansion card support on page 78). 5. Remove the green rails from the bracket by squeezing the tabs and sliding the rails out of the bracket. 6. Orient the drive with the connectors on the rear of the drive facing toward the tabs on the bracket rails. 7. Gently open the rails as shown in the following figure. Figure 5-67 Installing the drive in the rails 8. Lower the drive into the rails 2 as shown above. Align the four pins on the rails with the holes in the hard drive, and then snap the rails into place. 124 Chapter 5 Replacing components ENWW