HP Z800 HP Z800 Workstation Maintenance and Service Guide - Page 233
Screen message, Probable cause, Recommended action
UPC - 884962082454
View all HP Z800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 233 highlights
Table 6-10 POST error messages (continued) Screen message 518-Power supply wattage insufficient for hardware configuration Probable cause Recommended action Workstation configuration requires ● more power than the power supply can provide. ● Reduce the workstation power consumption. Replace the power supply with a high output power supply. 601-Diskette Controller Error Diskette controller circuitry or diskette 1. Run the Computer Setup (F10) utility. drive circuitry incorrect. 2. Verify cabling and replace defective cables if necessary. 3. Clear CMOS. 4. Replace the diskette drive. 5. Replace the system board. 605-Diskette Drive Type Error Mismatch in drive type. 1. Run the Computer Setup (F10) Utility. 2. Disconnect any other diskette controller devices (tape drives). 3. Clear the CMOS. 610-External Storage Device External storage device is not 1. Verify that the external device is present and Failure detected, is improperly connected, or connected properly. is defective. 2. Replace the external device. 611-Primary Floppy Port The flexible disk drive is configured at Select a new address for the flexible disk drive. Address Assignment Conflict a previously assigned address. 912-Computer Cover Has N/A Been Removed Since Last System Start Up No action required. 913-Front 1394 Not Connected Front 1394 device cable is Reconnect the 1394 cable and restart. disconnected from the system board. 916-Power Button Not Connected Power button cable is disconnected from the system board. Reconnect the cable and restart. 917-Front Audio Not Connected Front audio mechanism is missing or is 1. Reconnect or replace the front audio cable. not connected. 2. Reconnect or replace the front audio mechanism. 918-Front USB Not Connected Front USB is missing or is not connected. 1. Reconnect the Front USB connector to the system board. 2. Reconnect or replace the front USB mechanism. 920-Fatal error on QPI link X Fatal error detected on QPI link x, where x is 0 or 1. This type of error is identified on the line following. Potential system board problem; contact HP Support. 921-Fatal error on QPI Protocol link X Fatal error detected in QPI link x Potential system board problem; contact HP Support. protocol, where x is 0 or 1. This type of error is identified on the line following. 922-Fatal error on PCIe slot Fatal error occurred in the designated Move the card to a different slot. If the problem persists, X slot. replace the card. 923-Fatal error on ESI port 0 A fatal error occurred on ESI port 0. slot. Verify that the ESI port device is connected and working properly. 924-Fatal error on IOH core X Fatal error detected on IOH core x, where x is 0 or 1. This type of error is identified on the line following. Potential system board problem; contact HP Support. ENWW Diagnostic codes and errors 221