HP Z800 HP Z800 Workstation Maintenance and Service Guide - Page 88
Side access panel, Removing the side access panel
UPC - 884962082454
View all HP Z800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 88 highlights
Side access panel Before accessing the internal components of the workstation, you must remove the side access panel. This section describes how to remove and install the side access panel. Removing the side access panel WARNING! Before removing the workstation side access panel, be sure that the workstation is powered off and that the power cord is disconnected from the electrical outlet. 1. Disconnect power from the workstation (see Predisassembly procedures on page 74). 2. Remove locks that are present, such as cable lock or side access panel key lock. 3. Pull up on the handle and rotate the side access panel off the chassis 2 as shown in the following figure. Figure 5-3 Removing the side access panel Installing the side access panel 1. Align the bottom groove of the side access panel with the bottom edge of the chassis. 2. Rotate the side access panel toward the chassis and press firmly until the latch engages. 76 Chapter 5 Replacing components ENWW