HP Z800 HP Z800 Workstation Maintenance and Service Guide - Page 139
Expansion card guide/front fan holder
UPC - 884962082454
View all HP Z800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 139 highlights
4. Connect one end of the data cable to the hard drive as shown in the following figure. Figure 5-71 Connecting the data cables to the hard drives 5. Connect the opposite end of the data cable to the system board. Start with the lowest numbered port connector available on the system board. NOTE: Repeat steps 2-4 for the second hard drive. Expansion card guide/front fan holder This section describes how to remove and install the expansion card guide/front fan holder. Removing the expansion card guide/front fan holder 1. Disconnect power from the workstation (see Predisassembly procedures on page 74). 2. Remove the side access panel (see Removing the side access panel on page 76). 3. Remove the expansion card support (see Removing the expansion card support on page 78). 4. Remove the airflow guide (see Removing the airflow guide on page 77). 5. Remove expansion cards that are located in the card guide. ENWW Removing and installing components 127