HP ZBook 17 Maintenance and Service Guide - Page 74
Hard drive connector board and cable (federal models), Remove the hard drive connector board
View all HP ZBook 17 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Hard drive connector board and cable (federal models) Description Hard drive connector board Hard drive connector board cable Spare part number 906118-001 906117-001 (Hard Drive Hardware Kit) Before removing the hard drive connector board, follow these steps: 1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer on, and then shut it down through the operating system. 2. Disconnect the power from the computer by unplugging the power cord from the computer. 3. Disconnect all external devices from the computer. 4. Remove the service door (see Service door on page 36). 5. Remove the battery (see Battery on page 39). 6. Remove the primary hard drive (see Hard drive on page 42). 7. Remove the middle frame (see Middle frame on page 58). Remove the hard drive connector board: 1. Disconnect the cable from the system board (1), remove the two Phillips screws (2), and then lift the board and cable assembly from the computer (3). 60 Chapter 6 Removal and replacement procedures for authorized service provider parts