HP c3700 hp Visualize b2000 UNIX workstation service handbook (a5983-90039) - Page 125
Removing the Air Divider, Removing the I/O Fan from the Bracket
View all HP c3700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Field Replaceable Units FRU Removal and Replacement 3. Unscrew the two T-15 Torx screws that hold the workstation's air divider in place, as shown in Figure 4-51. Then grasp the edge of the air divider and pull it towards you to remove it from the workstation. Figure 4-51. Removing the Air Divider T-15 Torx Screw T-15 Torx Screw Air Divider 4. Disconnect the I/O fan and speaker cables from the system board. 5. Lift up on the fan/speaker mounting bracket tab from the hole in the drive bay housing. Then rotate the mounting bracket toward the chassis wall and rotate the fan/speaker mounting bracket out of the chassis. 6. Remove the I/O fan from the mounting bracket by slightly pulling the left and right fan mounting clips away from the fan, and then pulling the fan outward. See Figure 4-52. Figure 4-52. Removing the I/O Fan from the Bracket I/O Fan I/O Fan/Speaker Mounting Bracket Speaker Fan Mounting Clip Fan Mounting Clip Chapter 4 125