HP c3700 hp Visualize b2000 UNIX workstation service handbook (a5983-90039) - Page 27
Monitors
View all HP c3700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Product Information Monitors 2. Push the security loop's pin into the security loop pin hole, and insert the padlock's latch through the holes at the top and bottom of the security loop. This locks the left side panel. 3. Lock the padlock. The workstation's left side panel is now secure. Power Cord Connector Plug the workstation's power cord into the power cord connector to provide AC power to the system. Monitors The B2000 workstation supports monitors set to one of the following resolutions: • 1280×1024 color (stereo capable), 75Hz, VESA • 1600×1200 color, 75Hz, VESA • 1280×1024 color, 75 Hz, VESA The workstation must have either an HP-supported monitor running at 75 Hz with a 1280×1024 resolution, or a full multi-mode color monitor. Monitors with EVC, D-Sub, or 5 BNC connectors (RGB, vertical sync, horizontal sync) will function. NOTE The HP VISUALIZE-fxe graphics card will not function with older HP monitor types that use a sync on green signal. This includes monitors such as the HP 1097A/B/C/D, A2088A, and A2828A/B that only have 3 BNC connectors. Note that you can connect the B2000 workstation to earlier HP monitors with 15-pin miniature D-Sub cables using the A4168A adapter shipped with the workstation's accessory kit. Before using a monitor, you should become familiar with its controls, connectors, and indicators. For information about using a monitor, see the documentation that came with the monitor. Chapter 1 27