HP c3700 hp Visualize b2000 UNIX workstation service handbook (a5983-90039) - Page 37
CD Drive Configuration, Floppy Disk Drive Optional Configuration
View all HP c3700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Configuration System Hardware Configurations CD Drive Configuration The CD drive connects to the ATAPI (IDE) interface in the CD drive bay backplane within the B2000 workstation via a 40-pin ribbon cable, a 4-pin audio cable, and a 4-pin power cable. No interface addressing is required for the CD drive. However, as shown in Figure 2-1, the CD drive should have a jumper set on the CSEL (Cable Select) selection pins. (The CD drive should ship from the factory already jumpered for CSEL.) CAUTION CD drives are susceptible to mechanical and electrostatic shock. When handling the drive, always wear the static-grounding wrist strap that came in the CD drive kit. Always handle the drive carefully. Figure 2-1. CD Drive Jumper Setting (Rear View) Jumpered for CSEL To remove and replace a CD drive in the B2000 workstation, see the section titled "Removing and Replacing a CD Drive" on page 91. Floppy Disk Drive (Optional) Configuration The optional 3.5-inch floppy disk drive requires no ID, switch, or jumper settings. To remove a floppy disk drive from the B2000 workstation, see the section titled "Removing a Floppy Disk Drive" on page 96. To replace or install a floppy disk drive, see the section titled "Replacing or Installing a Floppy Disk Drive" on page 99. CAUTION Floppy disk drives are susceptible to mechanical and electrostatic shock. When handling the drive, always wear the static-grounding wrist strap that came in the floppy disk drive kit. Always handle the drive carefully. Chapter 2 37