HP c3700 hp Visualize b2000 UNIX workstation service handbook (a5983-90039) - Page 32
Overview, Workstation Configurations, System Hardware Configurations
View all HP c3700 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
Configuration Chapter Overview Chapter Overview This chapter contains the following main sections: • Workstation Configurations • System Hardware Configurations - Internal Storage Devices - Memory - I/O Cards - Monitor-Type Selection Workstation Configurations Refer to the HP Workstations website for a complete list of supported accessories, peripherals, and operating system versions for the HP VISUALIZE B2000 workstation. The URL for the website is: http://hp.unixworkstations.com System Hardware Configurations This section provides information for setting up or changing the configuration of the Field Replaceable Units (FRUs) for the B2000 workstation. Internal Storage Devices Hard Disk Drive Configuration The SCSI IDs for hard disk drives are hard-wired into the SCA Ultra2 Wide LVD SCSI interfaces on the system board within the B2000 workstation. Hence, SCSI IDs do not need to be set for the hard disk drives (up to two) installed in this workstation. From top to bottom, the pre-set SCSI IDs for hard disk drives are: 6 and 5. Similarly, no jumpers are installed at the factory, nor is any jumper installation required at the customer's site, on the hard disk drive model supported with the B2000 workstation. To remove and replace or install a hard disk drive, see the section titled "Hard Disk Drives" on page 104. Also see the next subsection, "Configuring a Hard Disk Drive as a File System," when removing or installing a hard disk drive. 32 Chapter 2