HP iPAQ rx4200 HP iPAQ Additional Product Information - Page 22
Deleting Wireless Network Settings, Configuring 802.1x Authentication Settings
View all HP iPAQ rx4200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 22 highlights
English The WLAN IP Address is shown here, as well as other detailed information about your current WLAN connection. Deleting Wireless Network Settings You can delete network settings you manually entered. However, if a network was automatically detected, your HP iPAQ may continue to automatically detect the network. To delete existing or available wireless network settings: 1. Tap Start > Today > iPAQ Wireless. 2. Tap the WLAN icon to turn WLAN on. 3. Tap the WLAN tab > View WLAN Networks > Wireless tab. 4. In the Configure Wireless Networks box, tap and hold the desired network settings. 5. Tap Remove Settings. Configuring 802.1x Authentication Settings Before performing these steps, determine if authentication information is needed by contacting your network administrator. 1. To manually enter information, tap Start > Today > iPAQ Wireless > WLAN tab > View WLAN Networks > Wireless tab. 2. In Configure Wireless Networks, select the desired network. 3. For increased security, tap 802.1X tab > Use IEEE 802.1x network access control. Then select the appropriate EAP type. NOTE The only two EAP types supported are PEAP and Smart Card or Certificate. Additional EAP types may be obtained from your network administrator or a third party. 16 Chapter 2 Connections ENWW