IBM 17011RS Maintenance Manual - Page 35
TotalStorage, DS400, models, storage, subsystem
![]() |
UPC - 000435304971
View all IBM 17011RS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
Chapter 3. IBM TotalStorage DS400 type 1700 (models 1RS, 2RD) storage subsystem The following chapter covers basic hardware maintenance information for the DS400 storage subsystem Type 1701 (models 1RS, 2RD). For more detailed information on the installation and use of the DS400 storage subsystem, refer to the DS300 and DS400 Hardware Installation and User's Guide. Note: The problem determination maps found in the DS300 and DS400 Problem Determination Guides provide you with additional diagnostic aids. General checkout Use the status LEDs, ServeRAID Manager software, and the Symptom-to-FRU index to diagnose problems. See "Monitoring status through software" on page 27, "Storage subsystem controls and LEDs" on page 24, and "Symptom-to-FRU index" on page 27. To diagnose problems with the DS400 storage subsystem, you can also refer to DS300 and DS400 Problem Determination Guides. The guide addresses problems that you might encounter with the DS300 or DS400 storage subsystem during and after installation. It uses flowcharting techniques to guide you in the isolation and correction of problems. General information The IBM TotalStorage DS400 storage subsystem model 1700-1RS comes with the following components: v One Fibre Channel RAID controller v 14 hard disk drive filler panels v Two power supplies The IBM TotalStorage DS400 storage subsystem model 1700-2RD comes with the following components: v Two Fibre Channel RAID controllers v 14 hard disk drive filler panels v Two power supplies Additional service information This section provides additional service information about the DS400 storage subsystem. Specifications The following information is a summary of the specifications of the storage subsystem. Depending on the storage subsystem model, some specifications might not apply. Racks are marked in vertical increments of 1.75 inches. Each increment is referred to as a unit, or "U." A 1-U-high device is 1.75 inches tall. © Copyright IBM Corp. 2004, 2005 21
![](/manual_guide/products/ibm-17011rs-maintenance-manual-ccee445/35.png)