IBM 17011RS Maintenance Manual - Page 37
drive, Drive, filler, panel, handle, latch
![]() |
UPC - 000435304971
View all IBM 17011RS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
Hard disk drive Drive filler panel Figure 11. DS400 storage subsystem front components Hard disk drive You can install up to 14 Ultra320 hot-swap hard disk drive customer replaceable units (CRUs) in the storage subsystem. Each hard disk drive CRU contains a hard disk drive and tray. Drive filler panel The storage subsystem comes without installed hard disk drives and contains filler panels in the unused drive bays. Before installing new drives, you must remove the filler panels and save them. Each of the 14 bays must always contain either a filler panel or a hard disk drive to maintain proper cooling and airflow. Tray handle and latch Use the blue latch on the tray handle to release or lock the hard disk drive in place. For information about installing and replacing a hard disk drive, see "Installing a hot-swap hard disk drive" on page 38 and "Replacing a hot-swap hard disk drive" on page 39. Rear view The following illustrations show the components at the rear of the DS400 storage subsystem. Power supplies Fibre Channel RAID controller (Side A) RAID controller filler panel (Side B) Figure 12. DS400 storage subsystem model 1700-1RS rear view Chapter 3. IBM TotalStorage DS400 type 1700 (models 1RS, 2RD) storage subsystem 23
![](/manual_guide/products/ibm-17011rs-maintenance-manual-ccee445/37.png)