IBM 865263Y Handbook - Page 27
c. Push the slide-bracket assemblies to the outermost positions on the rack.
View all IBM 865263Y manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
b. Place the tabs 2 of the slide rail assembly rear bracket between the nut bar 5 and the rear rack rail 1 . If necessary, loosen the screws 3 at the rear of the slide-rail assembly and adjust the length of the slide-rail to fit the rack. Tighten the adjustment screws 3 . c. Push the slide-bracket assemblies to the outermost positions on the rack. Make sure that the slides on the slide-rail assembly will extend out from the front of the rack. d. Tighten the screws at the front and rear of the U-unit. e. Attach the other slide rail assembly into the U-unit in the same way. Chapter 2. Installing the server in the rack enclosure 17
b. Place the tabs
±2²
of the slide rail assembly rear bracket between the nut
bar
±5²
and the rear rack rail
±1²
.
If necessary, loosen the screws
±3²
at
the rear of the slide-rail assembly and adjust the length of the slide-rail to fit
the rack.
Tighten the adjustment screws
±3²
.
c. Push the slide-bracket assemblies to the outermost positions on the rack.
Make sure that the slides on the slide-rail assembly will extend out from the
front of the rack.
d. Tighten the screws at the front and rear of the U-unit.
e. Attach the other slide rail assembly into the U-unit in the same way.
Chapter 2.
Installing the server in the rack enclosure
17