IBM 86605SU Maintenance Manual - Page 212
on the drive to the open position, the handle
![]() |
UPC - 087944475767
View all IBM 86605SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 212 highlights
3 Screws for half-high drive 4 Screw holes for slim-high drive 5 Drive tray 6 Drive 7 Connector for half-high drive 8 Screws for half-high drive connector To replace a drive in a hot-swap bay: 1. Unlock and open the server door (see "Preparing to Install Options" on page 220). Attention: To maintain proper system cooling, do not operate the server for more than two minutes without either a drive or a filler panel installed for each bay. 2. Remove the defective hard disk drive 1 by placing the handle 2 on the drive to the open position (perpendicular to the drive) and pulling the hot-swap tray from the bay. 3. Remove the hard disk drive from the tray: a. If the drive is a half-high drive, remove the two screws 8 that hold the connector 7 to the Netfinity 5500 - Type 8660 207
![](/manual_guide/products/ibm-86605su-maintenance-manual-e887055/212.png)