IBM 86605SU Maintenance Manual - Page 271
No Beep Symptoms, Control Panel System Error LED, Processor Board Component Locations
UPC - 087944475767
View all IBM 86605SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 271 highlights
No Beep Symptoms No Beep Symptom FRU/Action No beep and the system operates correctly. 1. Check speaker cables 2. Speaker 3. System Board No Beeps occur after successfully completing POST (The Power-On Status is disabled.) 1. Run Configuration/Setup, set the Start Options Power-On Status to enable. 2. Check speaker connection. 3. Speaker 4. System Board No AC power (Power supply AC LED is off) 1. Check the power cord 2. Power Supply (If two are installed, swap them to determine if one is defective.) 3. Power Backplane 4. Hot Swap Power AC Inlet Box No beep and no video 1. See "Undetermined Problems" on page 286. System will not power-up (Power supply AC LED is on) 1. See "Power Supply LED Errors" on page 273. Control Panel System Error LED The system error LED is turned on on when an error is detected. If the system error LED is on, remove the cover and check the diagnostic panel LEDs. The following is a complete list of diagnostic panel LEDs followed by the FRU/Action for replacing the problem. Notes 1. To locate the LEDs on the processor board see "Processor Board Component Locations" on page 227. 2. To locate the LEDs on the system board see "System Board Component Locations" on page 254. 3. Check the system error log for additional information before replacing a FRU. Diagnostic Panel LED CPU LED on (The LED next to the failing CPU is on.) FRU/Action 1. Processor 1 or 2 on (Processor 1 or 2). 2. Processor Board 266 Netfinity Server HMM