IBM 86605SU Maintenance Manual - Page 50

ServeRAID Controller Administration: This section provides instructions for copying the drive configuration to the ServeRAID controller, copying the ServeRAID controller configuration to the drives, initializing the ServeRAID controller configuration, and scanning for new drives. Copying the Drive Configuration to the ServeRAID Controller: You can copy the configuration information stored on the hard disk drives to the ServeRAID controller. This procedure is useful when you install drives from other systems. During the copy procedure, the ServeRAID controller automatically performs any necessary rearrangement of the configuration; then, the controller writes the new configuration information back to the reserved area on the configured hard disk drives. To copy the drive configuration information to the ServeRAID controller: 1. Click on the icon on the tool bar or select Adapter Configuration from the Advanced pull-down menu. A screen similar to the following appears. Adapter Configuration Adapter Configuration Options Copy Drive Configuration To Adapter Copy Adapter Configuration To Drives OK Cancel Initialize Adapter Configuration 2. Select Copy Drive Configuration to Adapter; then, click on OK. Copying the ServeRAID Controller Configuration to the Drives: You can copy the configuration information stored in the ServeRAID controller to all configured hard disk drives. To copy the ServeRAID controller configuration information to the drives: Netfinity 5500 - Type 8660 45