IBM 86605SU Maintenance Manual - Page 213
secure the connector to the drive with screws, Slim-high drives do not need
UPC - 087944475767
View all IBM 86605SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 213 highlights
hot-swap tray 5 ; then, remove the connector from the back of the drive. b. Remove the four screws 3 (for a half-high drive) or 4 (for a slim-high drive) that attach the drive 6 to the hot-swap tray, and remove the drive from the tray. 4. Place the new hard disk drive on the hot-swap tray and attach the drive to the tray using four screws, as follows: a. If the drive is a half-high drive, use screws 3 to attach the drive to the tray. If the drive is a slim-high drive, use screws in holes 4 to attach the drive to the tray. b. As you tighten each screw, press on the metal spring nearest the screw at the point indicated by the arrow on the illustration. c. If the drive is a half-high drive, plug the connector 7 to the back of the drive and secure the connector to the drive with screws 8 . (Slim-high drives do not need the connector.) 5. Install the hard disk drive in the hot-swap bay: a. Ensure the tray handle is open (that is, perpendicular to the drive). b. Align the drive/tray assembly so that it engages the guide rails in the bay. c. Push the drive assembly into the bay until the drive connects to the backplane. d. Push the tray handle to the right until it locks. 6. Check the hard disk drive status indicators to verify that the hard disk drive is installed properly. 7. Close and lock the server door. 208 Netfinity Server HMM