IBM 86605SU Maintenance Manual - Page 215
Removing the Rear Panel, Installing Devices on Side Rails, to Installing Devices on the NetBAY3 Base
UPC - 087944475767
View all IBM 86605SU manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
Removing the Rear Panel Note Do not remove the rear panel if you are not installing a device in the NetBAY3. 1. Remove the NetBAY3 rear panel. a. Remove the four screws. b. Lift the rear panel off. 2. After you remove the rear panel, do one of the following: Install a device on rails in the NetBAY3. (Go to "Installing Devices on Side Rails.") Install a cantilevered device in the NetBAY3. (Go to "Installing Cantilevered Devices" on page 212.) Install a device on the NetBAY3 base plate. (Go to "Installing Devices on the NetBAY3 Base Plate" on page 213.) Installing Devices on Side Rails: Installing devices that sit on side rails in a NetBAY3 is similar to installing these devices in a rack enclosure. The device side rails must be screwed to the NetBAY3 vertical mounting rails. Follow the instructions in the documentation that comes with the device and use the following illustrations as a guide. If you need to remove or move the cage nuts at the rear of the NetBAY3 to hold the rails, go to "Removing Cage Nuts" on page 211. 210 Netfinity Server HMM