IBM SAN40B-4 User Guide - Page 48
status, patterns, Ethernet - sfp
UPC - 883436031479
View all IBM SAN40B-4 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Port status LED patterns Each port has one LED port status indicator. Table 6 shows the LED color, status, and recommended action for these port LEDs. Table 6. Port LED patterns during normal operation LED name LED color Recommended Status of hardware action Port status No light No light or signal Check SFP and carrier (SFP or cable) cable. detected. Slow flashing green (flashing in two-second intervals) Port is online but segmented because of a loopback cable or incompatible switch connection. No action is required. Fast flashing green (flashing in half-second intervals) Port is online and an internal loopback diagnostic test is running. No action is required. Flickering green (steady with random flashes) Port is online and frames are flowing through the port. No action is required. Steady green Port is online (connected to external device) but has no traffic. No action is required. Slow flashing amber (flashing in two-second intervals) Port is disabled (because of diagnostics or the portDisable command). Verify the diagnostic tests are not running. Reenable the port using the portEnable command. Fast flashing amber Port is faulty. (flashing in half-second intervals) Check the management interface and the error log for details on the cause of status. Contact IBM Support if required. Steady amber (for more than five seconds) Port is receiving light or signal carrier at 4 Gbps; but is not yet online. No action required. Ethernet LED patterns Each Ethernet port has two LEDs, which are described in Table 7 Table 7. Ethernet LED patterns LED name Ethernet speed LED (right) LED color No light Steady green Status of hardware Port speed is 10 Mbps. Port speed is 100 Mbps. Recommended action No action is required. No action is required. 24 SAN40B-4 Installation, Service, and User's Guide