Invacare MVPS Owners Manual - Page 21

FRONT RIGGINGS SECTION 3 FRONT RIGGINGS Section 3 - Front Riggings includes the following: Installing/Removing/Adjusting the Footrest(s) Installing Elevating Legrests Raising/Lowering Elevating Legrests Adjusting Calfpads Using the Flip-Up Footrest Adjusting the Flip-Up Footrest Installing Adjustable Angle Flip-Up Footplate Hinge Adjusting Adjustable Angle Flip-Up Footplates Heel Loop Replacement Installing Impact Guards/Calf Strap Removing/Installing/Adjusting the Adjustable Angle One Piece Footboard WARNING After ANY adjustments, repair or service and BEFORE use, make sure all attachment hardware is tightened securely - otherwise, injury or damage may result. INSTALLING/REMOVING/ADJUSTING THE FOOTREST(S) SWINGAWAY FRONT FRAME (FIGURE 1) Installing/Removing. NOTE: Remove the footrests from the wheelchair by reversing this procedure. 1. Turn the footrest to the side (open footplate is perpendicular to wheelchair). INSTALLING/REMOVING Footrest Mounting Pin Footrest Release Lever Mounting Tube 2. Insert footrest mounting pin into mounting tube. 3. Push the footrest towards the inside of the wheelchair until it locks into place. ADJUSTING NOTE: The footplate will be on the inside of the wheelchair when locked in place. 4. Repeat this procedure for other footrest assembly. 5. To release the footrest, push the footrest release lever inward, rotate footrest outward. Footrest Coved Washer Hex Screw Part No. 1106638 FIGURE 1 - INSTALLING/REMOVING/ ADJUSTING THE FOOTREST(S) SWINGAWAY FRONT FRAME 21 MVP™ & MVP jr.™