Invacare MVPS Owners Manual - Page 23
Installing Elevating Legrests, 70° Mfx And 90° Footrests
View all Invacare MVPS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
FRONT RIGGINGS FRONT RIGGINGS SECTION 3 70° MFX AND 90° FOOTRESTS (FIGURE 3) Adjusting. 1. Remove any accessories that are attached to the footrests. 2. Remove the socket bolt, coved washer and locknut that secure the footplate to the footrest support. 3. Reposition the footplate to the desired height. 4. Reinstall the socket bolt through the mounting holes of the footplate and footrest support. WARNING DO NOT overtighten socket bolt and locknut. Footrest MUST be able to rotate upward from the horizontal to the vertical position. 5. Secure the footplate to the footrest support with the coved washer and locknut. Footrest Support Locknut Footplate Height Adjustment Holes Socket Bolt FIGURE 3 - INSTALLING/REMOVING/ADJUSTING THE FOOTREST(S) 70° MFX AND 90° FOOTRESTS INSTALLING ELEVATING LEGRESTS (FIGURE 4) 1. Insert the pivot tube into the legrest support and secure it with the bolt and nut. 2. Place legrest on the outside of the wheelchair and insert the mounting pin into the mounting tube. 3. Rotate legrest toward the inside of the wheelchair until it locks in place. NOTE: The footplate will be on the inside of the wheelchair when locked in place. 4. Repeat STEPS 1-3 for the opposite legrest. 5. After seated in wheelchair, adjust footrest to correct height by loosening nut and sliding the pivot tube up or down until desired height is obtained. 6. To release the legrest, push the legrest release handle toward the inside of the wheelchair and swing the legrest to the outside of the wheelchair. Part No. 1106638 23 MVP & MVP jr.