Invacare MVPS Owners Manual - Page 45

ARMS SECTION 6 ARMS USING/ADJUSTING DUAL POINT ARMS (FIGURE 3) WARNING Make sure the locking mechanism is secured before using the wheelchair. ADJUSTING ARMREST HEIGHT 1. Unlock the armrest by flipping the armrest release lever on the top front of the armrest to the UP (HORIZONTAL) position. Unlock (Horizontal) Lock (Vertical) 2. Adjust armrest to desired height. NOTE: Armrest locks MUST be in the unlocked position when placing armrest into the arm assembly. 3. Lock the armrest by pressing the release lever into the DOWN (VERTICAL) position when the desired armrest height is achieved. REMOVING ARMRESTS Armrest Release Lever Armrest Release Lever Height Adjustment Lever FIGURE 3 - USING/ADJUSTING DUAL POINT ARMS 1. Unlock the arm assembly by flipping the armrest release lever located on the side rail to the UP (HORIZONTAL) position. 2. Remove armrest from the wheelchair. REPLACING ARMRESTS NOTE: Armrest release levers MUST be in the unlocked position when placing armrests into the arm sockets. 1. Lock the armrest by pressing the armrest release lever into the DOWN (VERTICAL) position. REPLACING DUAL POINT ARM PAD (FIGURE 4) 1. Remove the phillips screws that secure the arm pad to the armrest assembly. Arm Pad 2. Replace arm pad and securely tighten with the existing phillips screws. REPLACING DUAL POINT ARM CLOTHING GUARDS (FIGURE 4) Screws Armrest Assembly NOTE: This procedure is for fixed height dual point arms ONLY. 1. Remove the four (4) screws that secure the existing clothing guard to the armrest assembly. 2. Replace the existing clothing guard with the new clothing guard and securely tighten with the existing hardware. 3. Repeat STEPS 1-2 for the opposite side if necessary. Phillips Screws Clothing Guard Screws FIGURE 4 - REPLACING DUAL POINT ARM PAD / REPLACING DUAL POINT ARM CLOTHING GUARDS Part No. 1106638 45 MVP™ & MVP jr.™