Invacare MVPS Owners Manual - Page 41

SEAT SEAT SECTION 5 INSTALLING FABRIC CLOTHING GUARDS (FIGURE 4) 1. Remove the seat cushion, if necessary. 2. Secure the fastening straps of the fabric clothing guards to the fastening straps on the seat upholstery. 3. Reinstall the seat cushion, if necessary. 4. Remove the two (2) phillips screws that secure the back upholstery to the back canes. 5. Position the D-rings on the mounting holes in the back canes. 6. Reinstall the two (2) phillips screws. Torque to 20-25 in./lbs. 7. Run the nylon cord evenly through the two (2) D-rings. 8. Run the nylon cord through the cord lock. 9. Push star wheel into cord lock to hold the nylon cord in place. 10. Tie a knot in the nylon cord and cut the excess, if desired. Fabric Clothing Guard Fastening Strap Seat Upholstery Cord Lock Phillips Screw, D-ring Phillips Screw, D-ring Star Wheel Nylon Cord FIGURE 4 - INSTALLING FABRIC CLOTHING GUARDS INSTALLING RIGID CLOTHING GUARDS (FIGURE 5) 1. Position the threaded and unthreaded half clamps on inside and outside of the wheelchair frame. NOTE: Make sure the threaded half clamp is on the outside of the wheelchair frame. Wheelchair Frame Half Clamp Socket Screw 2. Loosely install the washer and socket screw into the unthreaded and threaded half clamps. Washer 3. Determine the desired rigid clothing guard position and securely tighten the two (2) half clamps together with the socket screw. 4. Insert the rigid clothing guard into the slot on the threaded half clamp as shown in FIGURE 5. Slot Threaded Half Clamp FIGURE 5 - INSTALLING RIGID CLOTHING GUARDS 5. Repeat STEPS 1-4 for the opposite rigid side guard. Part No. 1106638 41 MVP™ & MVP jr.™