Invacare MVPS Owners Manual - Page 47

ARMS ARMS SECTION 6 ADJUSTING THE T-ARMS ADJUSTING T-ARM HEIGHT (FIGURE 6) 1. Unlock the T-arm by flipping the T-arm release lever towards the inside of the wheelchair. NOTE: If necessary, pull out on the T-arm release lever and rotate 180o so it can be flipped towards the outside of the wheelchair. 2. Slide the T-arm to one (1) of: A. Low Height T-Arms - Nine (9) positions. B. High Height T-Arms - Seven (7) positions. NOTE: If the inside T-arm post does not slide up and down in the outside T-arm post as desired, perform one (1) of the following: A. Tighten - Tightening the set screws on the outside T-arm post will make it harder to move the inside T-arm post up and down. B. Loosen - Loosening the set screws on the outside T-arm post will make it easier to move the inside T-arm post up and down. 3. Lock the T-arm by flipping the T-arm release lever towards the front of the wheelchair. Set Screws Inside T-Arm Post Outside T- Arm Post T-Arm Release Lever Unlocked Position T-Arm Release Lever - Locked Position FIGURE 6 - ADJUSTING T-ARM HEIGHT ADJUSTING T-ARM WIDTH (FIGURE 7) 1. Remove the two (2) phillips screws that secure the arm pad to the arm tube. 2. Turn the arm pad around and reposition the arm pad on the arm tube. 3. Re-secure the arm pad to the arm tube with the two (2) phillips screws. Tighten securely. 4. Repeat for the opposite side, if necessary. Part No. 1106638 Arm Pad Arm Tube Phillips Screw Phillips Screw FIGURE 7 - ADJUSTING T-ARM WIDTH 47 MVP™ & MVP jr.™