Invacare MVPS Owners Manual - Page 44

ARMS SECTION 6 ARMS ADJUSTING HALF ARM HEIGHT (FIGURE 2) 1. Remove the half arm from the arm socket. 2. Remove the hex screw, two (2) washers and locknut mounted in the arm socket that determine the half arm height. 3. Reposition hex screw and one (1) washer to one (1) of three (3) positions in the arm socket depending on the desired height. 4. Retighten the hex screw and washer to the arm socket with the remaining washer and locknut. 5. Reinstall the half arm into the arm socket. 6. Repeat STEPS 1-5 for the opposite side, if necessary. NOTE: If desired height is still not obtainable, refer to INSTALLING THE HALF ARM in this section of the manual, to reposition the arm socket on the wheelchair with the top hex screw in the top mounting hole of the arm socket and the bottom hex screw in the slot of the arm socket. Half Arm Arm Socket Locknut Washers Three (3) Mounting Positions Hex Screw FIGURE 2 - ADJUSTING HALF ARM HEIGHT MVP™ & MVP jr.™ 44 Part No. 1106638