JVC DR-HD100-80 User Guide - Page 87

DR-HD100 Functions • EXT CTL FILE Creates a new file during a record session without losing frames. TIME CODE EXT, REC RUN, FREE RUN, REGEN The DR-HD100 2.0 upgrade provides the additional functions TC REC RUN, TC FREE RUN, and TC REGEN in HD RECORDER mode. This functionality is only active when the HD FORMAT is set to QUICKTIME. In M2T mode, all TC modes act as TC EXT. The following are timecode (TC) functions. • TC EXT Group Default Records the incoming source timecode. If the timecode is not running, the DR-HD100 records the same timecode number in each recorded frame. Choose TC EXT mode to clear any stored number. • TC REC RUN DV mode or 2.0 upgrade only In this mode, after a power cycle, the DR-HD100 starts its TC record count using the TC SET value. Later recordings add to the last value recorded. A power cycle resets the TC record value to the TC SET value. • TC FREE RUN DV mode or 2.0 upgrade only This function causes the DR-HD100 to begin counting from the value stored by TC SET. • A number entered through TC SET is not stored and available to the DR-HD100 until exiting TC SET. Only then does the DR-HD100 begin counting using that number. • TC REGEN DV mode or 2.0 upgrade only When the DR-HD100 powers up in TC REGEN mode, it: • Reads the timecode of the last track recorded. • Adds 1 to the number. • Stores the new timecode as the number that will be assigned to the first frame of the next recording session. If the drive is empty, i.e. no existing recordings, the DR-HD100 uses the TC SET value. TC SET and UB SET Can Be Set at the Same Time Both parameters, TC SET and UB SET, may be set and are not mutually exclusive as in some groups, i.e. LCDLIGHT. ProHD DR-HD100 Portable DTE Recorder 71