Kenmore 8075 Use and Care Manual - Page 13

1= Loosen or remove center, silver-colored terminal block screw. 2. Place the hooked end of the neutral wire (white or center wire) of direct wire cable under the center screw of terminal block (hook facing right). Squeeze hooked end together. Tighten screw. Optional 3-wire connection Use for direct wire or power supply cord where local codes do not permit connecting cabinet-ground conductor to neutral wire. 1. Remove center, silver-colored terminal block screw. 2. Remove neutral ground wire from internal ground conductor screw. Connect neutral ground wire and the neutral wire (white or center wire) of power supply cord/cable under center, silver-colored terminal block screw. Tighten screw. L_ C E D A. Neutral wire (white or center wire) B. Center sliver-colored terminal block screw C. Neutral ground wire D. Internal ground conductor screw E. 3/4"(1.9 cm) UL listed, strain relief Place the hooked ends of the other power supply cable wires under the outer terminal block screws (hooks facing right). Squeeze hooked ends together. Tighten screws. LB C iD E A. Neutral wire (white or center wire) B. Neutral ground wire C. External ground conductor screw D. Grounding path determined by a qualified electrician E. Internal ground conductor location Connect the other wires to outer terminal block screws. Tighten screws. 4. Tighten strain relief screw. 5. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 6. You have completed your electrical connection. Now go to "Venting Requirements." 4. Tighten strain relief screws. 5. Move the green painted screw from the internal to the external ground conductor location. Connect a separate copper ground wire from the external ground conductor screw to an adequate ground. 6. Insert tab of terminal block cover into slot of dryer rear panel. Secure cover with hold-down screw. 13