Lantronix IntelliBox-I/O IntelliBox-I/O - User Guide - Page 61
Tunnel – Serial Settings Serial Settings, Buffer Size, Current Configuration, Reset, Cancel
View all Lantronix IntelliBox-I/O manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
7: Network, Serial Line, Tunnel, and Modbus Settings Tunnel - Serial Settings Page If you click Serial Settings at the top of one of the Tunnel pages, the Tunnel - Serial Settings page displays. This page shows the settings for the tunnel selected at the top of the page and lets you change the settings. If you change the Buffer Size value, you must reboot the IntelliBox for the change to take effect. Changing the other values does not require a reboot. Under Current Configuration, Buffer Size has a Reset link that lets you reset the buffer size to its default value. If you click this link, a message tells you that you will have to reboot the IntelliBox. Click OK to proceed or Cancel to cancel the operation. Note: The default protocol is Tunnel. The protocol on the line 1 page must be Tunnel for tunneling to operate. Figure 7-6 Tunnel - Serial Settings Page Table 7-4 Tunnel - Serial Settings Page Tunnel - Serial Settings Page Line Settings Description Lists current serial settings for the line. Protocol Lists the protocol being used on the line. Buffer Size DTR Enter the size of the buffer used to receive data on the serial line. Range = 1 to 4096 bytes. Default is 2048 bytes. Changing this value requires you to reboot the IntelliBox. Select Asserted while connected to assert DTR whenever a connect or an accept mode tunnel connection is active. Select Continuously Asserted (default) to assert DTR regardless of the status of a tunnel connection. Unasserted sets DTR off always. IntelliBox-I/O 2100 User Guide 61