Lenovo ThinkStation D20 Hardware Maintenance Manual - Page 63

Diagnostic Error Code 000-197-XXX BIOS test warning 000-198-XXX BIOS test aborted 000-199-XXX BIOS test failed, cause unknown 000-250-XXX BIOS APM failure 000-270-XXX BIOS ACPI failure 001-000-XXX System Test Passed 001-00X-XXX System Error 001-01X-XXX System Error 001-024-XXX System Addressing test failure 001-025-XXX System Checksum Value error 001-026-XXX System FLASH data error 001-027-XXX System Configuration/Setup error 001-032-XXX System Device Controller failure 001-034-XXX System Device Buffer Allocation failure 001-035-XXX System Device Reset condition detected 001-036-XXX System Register error FRU/Action 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility" on page 41 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility" on page 41 2. Flash the system and retest. See "Flash update procedures" on page 251 3. Go to "Undetermined problems" on page 75 1. Go to "Undetermined problems" on page 75 2. Flash the system and re-test 3. Replace component under function test 1. Flash the system. See "Flash update procedures" on page 251 2. System board 1. Flash the system. See "Flash update procedures" on page 251 2. System board No action System board System board System board 1. Flash the system. See "Flash update procedures" on page 251 2. System board 1. Flash the system. See "Flash update procedures" on page 251 2. System board 1. Run Setup 2. Flash the system. See "Flash update procedures" on page 251 3. System board System board 1. Reboot the system 2. Flash the system. See "Flash update procedures" on page 251 3. Run memory test 4. System board System board System board Chapter 9. Symptom-to-FRU Index 55