Lenovo ThinkStation D20 Hardware Maintenance Manual - Page 76
Voltage Sensors Test Passed, Microprocessor Test Passed
View all Lenovo ThinkStation D20 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 76 highlights
Diagnostic Error Code 086-199-XXX Mouse Port interface test failed, cause unknown 089-000-XXX Microprocessor Test Passed 089-XXX-XXX Microprocessor failure 089-195-XXX Microprocessor Test aborted by user 089-196-XXX Microprocessor test halt, error threshold exceeded 089-197-XXX Microprocessor test warning 089-198-XXX Microprocessor test aborted 089-199-XXX Microprocessor test failed, cause unknown 170-000-XXX Voltage Sensor(s) Test Passed 170-0XX-XXX Voltage Sensor(s) failure 170-195-XXX Voltage Sensor(s) Test aborted by user 170-196-XXX Voltage Sensor(s) test halt, error threshold exceeded 170-197-XXX Voltage Sensor(s) test warning 170-198-XXX Voltage Sensor(s) test aborted FRU/Action 1. See "Undetermined problems" on page 75 2. Flash the system and re-test. See "Flash update procedures" on page 251 3. Replace component under function test No action 1. Microprocessor(s) 2. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility" on page 41 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. Flash the system. See "Flash update procedures" on page 251 2. Go to "Undetermined problems" on page 75 1. See "Undetermined problems" on page 75 2. Flash the system and re-test. See "Flash update procedures" on page 251 3. Replace component under function test No action 1. Flash system 2. System board Information only Re-start the test, if necessary 1. Press F3 to review the log file 2. Re-start the test to reset the log file 1. Make sure the component that is called out is connected and/or enabled. See Chapter 6 "Using the Setup Utility" on page 41 2. Re-run test 3. Replace the component that is called out in warning statement 4. Replace the component under test 1. If a component is called out, make sure it is connected and/or enabled. See Chapter 6 "Using the Setup Utility" on page 41 2. Flash the system and re-test. See "Flash update procedures" on page 251 3. Go to "Undetermined problems" on page 75 68 ThinkStation Hardware Maintenance Manual