Miele TXI 680 WP Eco and Steam Operating instructions/Installation instruction - Page 59

after a program, has been inter

Get Miele TXI 680 WP Eco and Steam PDF manuals and user guides View all Miele TXI 680 WP Eco and Steam manuals
Add to My Manuals
Save this manual to your list of manuals

Page 59 highlights

Frequently Asked Questions Message Possible cause and solution  Empty container See The condensed water container is full or there is a  lights up after kink in the drain hose. a program has  Empty out the condensed water container. been canceled.  Check the drain hose. To switch the fault message off:  Open and close the door while the dryer is switched on or switch the dryer off and back on again.  Soft Steam This is to remind you that water is taken from the condensed water container when the Soft Steam program is being used. The condensed water container must be filled with water to at least the -min- marker.  Fill the condensed water container. To switch off the message:  Confirm with OK.  Open & close door This it to remind you to load the laundry when the SoftSteam program is selected.  Load the laundry in the drum.  Blockage detected. The laundry is unevenly distributed or has rolled up. See  lights up  Open the door and untangle the laundry, and re- after a program move a few items, if necessary. has been inter-  Switch the dryer off and then on again. rupted.  Start a program.   Service Fault F There is no obvious cause. XXX lights up af-  Switch the dryer off and then on again. ter a program  Start a program. has been interrupted. If the program is interrupted again and an error message appears, there is a fault. Contact Miele Service. 59

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
Frequently Asked Questions
59
Message
Possible cause and solution
Empty container See
 lights up after
a program has
been canceled.
The condensed water container is full or there is a
kink in the drain hose.
Empty out the condensed water container.
Check the drain hose.
To switch the fault message off:
Open and close the door while the dryer is
switched on or switch the dryer off and back on
again.
Soft Steam
This is to remind you that water is taken from the
condensed water container when the
Soft Steam
pro-
gram is being used. The condensed water container
must be filled with water to at least the
–min–
marker.
Fill the condensed water container.
To switch off the message:
Confirm with
OK
.
Open & close door
This it to remind you to load the laundry when the
SoftSteam
program is selected.
Load the laundry in the drum.
Blockage detected.
See 
lights up
after a program
has been inter-
rupted.
The laundry is unevenly distributed or has rolled up.
Open the door and untangle the laundry, and re-
move a few items, if necessary.
Switch the dryer off and then on again.
Start a program.
 Service Fault F
XXX
lights up af-
ter a program
has been inter-
rupted.
There is no obvious cause.
Switch the dryer off and then on again.
Start a program.
If the program is interrupted again and an error mes-
sage appears, there is a fault. Contact Miele Service.