Netgear GSM7228PS 7300 Series Managed Switch CLI Refernce Manual for Software - Page 313

Managed Switch CLI Manual, Release 8.0.3 Format Mode no trapflags { all | errors {all | authentication-failure | bad-packet | config-error | virtauthentication-failure | virt-bad-packet | virt-config-error} | if-rx {all | if-rx-packet} | lsa {all | lsa-maxage | lsa-originate} | overflow {all | lsdb-overflow | lsdb-approaching-overflow} | retransmit {all | packets | virt-packets} | rtb {all, rtb-entry-info} | state-change {all | if-state-change | neighbor-state-change | virtifstatechange | virtneighbor-state-change} } Router OSPF Config show ip ospf This command displays information relevant to the OSPF router. Format Mode show ip ospf Privileged EXEC Note: Some of the information below displays only if you enable OSPF and configure certain features. Term Router ID OSPF Admin Mode ASBR Mode RFC 1583 Compatibility Definition A 32-bit integer in dotted decimal format identifying the router, about which information is displayed. This is a configured value. Shows whether the administrative mode of OSPF in the router is enabled or disabled. This is a configured value. Indicates whether the ASBR mode is enabled or disabled. Enable implies that the router is an autonomous system border router. Router automatically becomes an ASBR when it is configured to redistribute routes learnt from other protocol. The possible values for the ASBR status is enabled (if the router is configured to re-distribute routes learned by other protocols) or disabled (if the router is not configured for the same). Indicates whether 1583 compatibility is enabled or disabled. This is a configured value. Routing Commands v1.0, July 2010 4-65