Netgear GSM7228PS 7300 Series Managed Switch CLI Refernce Manual for Software - Page 552

MbufsFree 150 MbufsRxUsed 0 Total Rx Norm Alloc Attempts Total Rx Mid2 Alloc Attempts Total Rx Mid1 Alloc Attempts Total Rx High Alloc Attempts Total Tx Alloc Attempts Total Rx Norm Alloc Failures Total Rx Mid2 Alloc Failures Total Rx Mid1 Alloc Failures Total Rx High Alloc Failures Total Tx Alloc Failures 26212 4087 188943 384555 2478536 0 0 0 0 0 Managed Switch CLI Manual, Release 8.0.3 show running-config Use this command to display or capture the current setting of different protocol packages supported on the switch. This command displays or captures commands with settings and configurations that differ from the default value. To display or capture the commands with settings and configurations that are equal to the default value, include the [all] option. Note: Show running-config does not display the User Password, even if you set one different from the default. The output is displayed in script format, which can be used to configure another switch with the same configuration. If the optional is provided with a file name extension of ".scr", the output is redirected to a script file. Note: If you issue the show running-config command from a serial connection, access to the switch through remote connections (such as Telnet) is suspended while the output is being generated and displayed. Note: If you use a text-based configuration file, the show running-config command will only display configured physical interfaces, i.e. if any interface only contains the default configuration, that interface will be skipped from the show running-config command output. This is true for any configuration mode that contains nothing but default configuration. That is, the command to enter a particular config mode, followed immediately by its 'exit' command, are both omitted from the show running-config command output (and hence from the startup-config file when the system configuration is saved.) Utility Commands v1.0, July 2010 9-15