Netgear GSM7228PS 7300 Series Managed Switch CLI Refernce Manual for Software - Page 89

Managed Switch CLI Manual, Release 8.0.3 switchport protected (Interface Config) Use this command to add an interface to a protected port group. The parameter identifies the set of protected ports to which this interface is assigned. You can only configure an interface as protected in one group. Note: Port protection occurs within a single switch. Protected port configuration does not affect traffic between ports on two different switches. No traffic forwarding is possible between two protected ports. Default Format Mode unprotected switchport protected Interface Config no switchport protected (Interface Config) Use this command to configure a port as unprotected. The groupid parameter identifies the set of protected ports to which this interface is assigned. Format Mode no switchport protected Interface Config show switchport protected This command displays the status of all the interfaces, including protected and unprotected interfaces. Format Mode Term Group ID show switchport protected • Privileged EXEC • User EXEC Definition The number that identifies the protected port group. Switching Commands v1.0, July 2010 3-53