Netgear GSM7228PS 7300 Series Managed Switch CLI Refernce Manual for Software - Page 569

Managed Switch CLI Manual, Release 8.0.3 copy The copy command uploads and downloads files to and from the switch. You can also use the copy command to manage the dual images (image1 and image2) on the file system. Upload and download files from a server by using TFTP or Xmodem. SFTP and SCP are available as additional transfer methods if the software package supports secure management. Format Mode copy Privileged EXEC Replace the and parameters with the options in table below. For the source or destination, use one of the following values: {xmodem | tftp://|// [noval] | sftp|scp://@|||} For TFTP, SFTP and SCP, the parameter is the IP address or host name of the server, is the path to the file, and is the name of the file you want to upload or download. For SFTP and SCP, the parameter is the username for logging into the remote server via SSH. Note: is also a valid parameter for routing packages that support IPv6. Warning: Remember to upload the existing Switch CLI.cfg file off the switch prior to loading a new release image in order to make a backup. For platforms that support a USB device, the copy command can be used to transfer files from and to the USB device. The syntax for the USB file is: usb://. The USB device can be either a source or destination in the copy command. It cannot be used as both source and destination in a given copy command. Parameters for the copy command are listed in the following table: Source nvram:backup-config Destination nvram:startup-config Description Copies the backup configuration to the startup configuration. Utility Commands v1.0, July 2010 9-32