Netgear GSM7228PS 7300 Series Managed Switch CLI Refernce Manual for Software - Page 390

Managed Switch CLI Manual, Release 8.0.3 Parameters hash-masklength priority Description Length of a mask (32 bits maximum) that is to be ANDed with the group address before the hash function is called. All groups with the same seed hash correspond to the same RP. For example, if this value was 24, only the first 24 bits of the group addresses matter. This allows you to get one RP for multiple groups. Priority of the candidate BSR. The range is an integer from 0 to 255. The BSR with the larger priority is preferred. If the priority values are the same, the router with the larger IP address is the BSR. The default value is 0. no ipv6 pimsm bsr-candidate This command is used to disable the router to announce its candidacy as a bootstrap router (BSR). Format Mode no ipv6 pimsm bsr-candidate interface [hash-masklength] [priority] Global Config ipv6 pimsm dr-priority Use this command to set the priority value for which a router is elected as the designated router (DR). Default Format Mode 1 ipv6 pimsm dr-priority Interface Config no ipv6 pimsm dr-priority Use this command to disable the interface from being the BSR border. Format Mode no ipv6 pimsm dr-priority Interface Config ipv6 pimsm hello-interval This command is used to configure the PIM-SM hello interval for the specified interface. The hello interval range is 0-18000 is specified in seconds. IPv6 Multicast Commands 6-9 v1.0, July 2010