Netgear GSM7228PS 7300 Series Managed Switch CLI Refernce Manual for Software - Page 622

Managed Switch CLI Manual, Release 8.0.3 Field Receiver Max Datagram Size Receiver IP Receiver Port Description The maximum number of data bytes that can be sent in a single sample datagram. The management entity should set this value to avoid fragmentation of the sFlow datagrams. The allowed range is 200 to 9116). The default is 1400. The sFlow receiver IP address. If set to 0.0.0.0, no sFlow datagrams will be sent. The default is 0.0.0.0. The destination Layer4 UDP port for sFlow datagrams. The range is 1-65535. The default is 6343. no sflow receiver Use this command to set the sFlow collector parameters back to the defaults. Format Mode no sflow receiver {ip | maxdatagram | owner timeout | port } Global Config sflow sampler A data source configured to collect flow samples is called a poller. Use this command to configure a new sFlow sampler instance for this data source if is valid. Format Mode sflow sampler { | rate | maxheadersize } Interface Config Field Description Receiver Index Maxheadersize The sFlow Receiver for this sFlow sampler to which flow samples are to be sent. A value of zero (0) means that no receiver is configured, no packets will be sampled. Only active receivers can be set. If a receiver expires, then all samplers associated with the receiver will also expire. Possible values are 1-8. The default is 0. The maximum number of bytes that should be copied from the sampler packet. The range is 20-256. The default is 128. When set to zero (0), all the sampler parameters are set to their corresponding default value. Utility Commands v1.0, July 2010 9-85