Netgear M4100-D10-POE CLI Manual - Page 160

ProSafe M4100 and M7100 Managed Switches than the Snooping Querier's address, it stops sending periodic queries. If the Snooping Querier wins the election, then it will continue sending periodic queries. Default Format Mode disabled set igmp querier election participate VLAN Config no set igmp querier election participate Use this command to set the Snooping Querier not to participate in querier election but go into non-querier mode as soon as it discovers the presence of another querier in the same VLAN. Format Mode no set igmp querier election participate VLAN Config show igmpsnooping querier Use this command to display IGMP Snooping Querier information. Configured information is displayed whether or not IGMP Snooping Querier is enabled. Format Mode show igmpsnooping querier [{detail | vlan }] Privileged EXEC When the optional argument is not used, the command displays the following information. Field Description Admin Mode Indicates whether or not IGMP Snooping Querier is active on the switch. Admin Version The version of IGMP that will be used while sending out the queries. Querier Address The IP Address which will be used in the IPv4 header while sending out IGMP queries. It can be configured using the appropriate command. Query Interval The amount of time in seconds that a Snooping Querier waits before sending out the periodic general query. Querier Timeout The amount of time to wait in the Non-Querier operational state before moving to a Querier state. Switching Commands 160