Netgear M4100-D10-POE CLI Manual - Page 238
Number of Active, Split Horizon Mode
View all Netgear M4100-D10-POE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 238 highlights
ProSafe M4100 and M7100 Managed Switches Parameter Description Maximum Paths The maximum number of next hops in an OSPF route Routing for Networks The address ranges configured with an OSPF network command Distance The administrative distance (or route preference) for intra-area, inter-area, and external routes Default Route Advertise Whether OSPF is configured to originate a default route Always Whether default advertisement depends on having a default route in the common routing table Metric The metric configured to be advertised with the default route Metric Type The metric type for the default route Redist Source A type of routes that OSPF is redistributing Metric The metric to advertise for redistributed routes of this type Metric Type The metric type to advertise for redistributed routes of this type Subnets Whether OSPF redistributes subnets of classful addresses, or only classful prefixes Dist List A distribute list used to filter routes of this type. Only routes that pass the distribute list are redistributed Number of Active The number of OSPF areas with at least one interface running on this router. Also broken Areas down by area type ABR Status Whether the router is an area border router. A router is an area border router if it has interfaces that are up in more than one area ASBR Status Whether the router is an autonomous system boundary router. The router is an ASBR if it is redistributing any routes or originating a default route RIP Split Horizon Mode Whether RIP advertises routes on the interface where they were received Default Metric The metric assigned to redistributed routes Default Route Advertise Whether this router is originating a default route Distance The administrative distance for RIP routes Redistribution A table showing information for each source protocol (connected, static, bgp, and ospf). For each of these sources the distribution list and metric are shown. Fields which are not configured are left blank. For ospf, configured ospf match parameters are also shown Interface The interfaces where RIP is enabled and the version sent and accepted on each interface Routing Commands 238