Netgear M4100-D10-POE CLI Manual - Page 427
ipv6 pim bsr-border, ipv6 pim bsr-candidate
View all Netgear M4100-D10-POE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 427 highlights
ProSafe M4100 and M7100 Managed Switches Term Definition Hello Interval Hello interval value. The frequency at which PIM hello messages are transmitted on this interface. By default, the value is 30 seconds. Join-prune Interval Join-prune interval value. DR Priority DR priority configured on this interface. This is not applicable if the interface mode is Dense. BSR Border Indicates whether the interface is configured as a BSR border. Neighbor Count Number of PIM neighbors discovered on the interface. This field is displayed only when the interface is operational. Designated-Router IP address of the elected DR on the interface. This field is displayed only when the interface is operational. (Switch) #show ipv6 pim interface 0/1 Interface 0/1 Mode Dense Hello Interval (secs 30 Join Prune Interval (secs 60 DR Priority 1 BSR Border Disabled ipv6 pim bsr-border Use this command to prevent bootstrap router (BSR) messages from being sent or received through an interface. Default Format Mode disabled ipv6 pim bsr-border Interface Config no ipv6 pim bsr-border Use this command to disable the interface from being the BSR border. Format Mode no ipv6 pim bsr-border Interface Config ipv6 pim bsr-candidate Use this command to configure the router to announce its candidacy as a bootstrap router (BSR). Default None IPv6 Multicast Commands 427