Netgear M4100-D10-POE CLI Manual - Page 272

ProSafe M4100 and M7100 Managed Switches area virtual-link transmit-delay (OSPF) This command configures the transmit delay for the OSPF virtual interface on the virtual interface identified by and . The parameter is the Router ID of the neighbor. The range for seconds is 0-3,600 (1 hour). Default Format Mode 1 area virtual-link transmit-delay Router OSPF Config no area virtual-link transmit-delay This command resets the default transmit delay for the OSPF virtual interface to the default value. Format Mode no area virtual-link transmit-delay Router OSPF Config auto-cost (OSPF) By default, OSPF computes the link cost of each interface from the interface bandwidth. Faster links have lower metrics, making them more attractive in route selection. The configuration parameters in the auto-cost reference bandwidth and bandwidth commands give you control over the default link cost. You can configure for OSPF an interface bandwidth that is independent of the actual link speed. A second configuration parameter allows you to control the ratio of interface bandwidth to link cost. The link cost is computed as the ratio of a reference bandwidth to the interface bandwidth (ref_bw / interface bandwidth), where interface bandwidth is defined by the bandwidth command. Because the default reference bandwidth is 100 Mbps, OSPF uses the same default link cost for all interfaces whose bandwidth is 100 Mbps or greater. Use the auto-cost command to change the reference bandwidth, specifying the reference bandwidth in megabits per second (Mbps). The reference bandwidth range is 1-4294967 Mbps. The different reference bandwidth can be independently configured for OSPFv2 and OSPFv3. Default Format Mode 100 Mbps auto-cost reference-bandwidth Router OSPF Config no auto-cost reference-bandwidth (OSPF) Use this command to set the reference bandwidth to the default value. Format Mode no auto-cost reference-bandwidth Router OSPF Config Routing Commands 272