Netgear M4100-D10-POE CLI Manual - Page 27

ProSafe M4100 and M7100 Managed Switches show port description This command displays the port description for every port. Format Mode show port description Privileged EXEC Term Interface Description Definition Valid slot and port number separated by forward slashes Shows the port description configured via the "description" command show port status This command displays the Protocol-Based VLAN information for either the entire system, or for the indicated group. Format Mode show port status { | all} Privileged EXEC Term Interface Media Type STP Mode Physical Mode Physical Status Link Status Loop Status Partner Flow Control Definition Valid slot and port number separated by forward slashes. "Copper" or "Fiber" for combo port. Indicate the spanning tree mode of the port. Either "Auto" or fixed speed and duplex mode. The actual speed and duplex mode. Whether the link is Up or Down. Whether the port is in loop state or not. Whether the remote side is using flow control or not. Loopback Interface Commands The commands in this section describe how to create, delete, and manage loopback interfaces. A loopback interface is always expected to be up. This interface can provide the source address for sent packets and can receive both local and remote packets. The loopback interface is typically used by routing protocols. To assign an IP address to the loopback interface, see ip address on page 228. To assign an IPv6 address to the loopback interface, see ipv6 address on page 359. Switching Commands 27