Netgear M4100-D10-POE CLI Manual - Page 474

ProSafe M4100 and M7100 Managed Switches Format Mode mac access-list extended Global Config no mac access-list extended This command deletes a MAC ACL identified by from the system. Format Mode no mac access-list extended Global Config mac access-list extended rename This command changes the name of a MAC access control list (ACL). The parameter is the name of an existing MAC ACL. The parameter is a case-sensitive alphanumeric string from 1 to 31 characters uniquely identifying the MAC access list. This command fails if a MAC ACL by the name exists. Format Mode mac access-list extended rename Global Config {deny | permit} (MAC ACL) This command creates a new rule for the current MAC access list. Each rule is appended to the list of configured rules for the list. Note: The 'no' form of this command is not supported, since the rules within a MAC ACL cannot be deleted individually. Rather, the entire MAC ACL must be deleted and respecified. Note: An implicit 'deny all' MAC rule always terminates the access list. A rule might either deny or permit traffic according to the specified classification fields. At a minimum, the source and destination MAC value must be specified, each of which might be substituted using the keyword any to indicate a match on any value in that field. The remaining command parameters are all optional, but the most frequently used parameters appear in the same relative order as shown in the command format. The Ethertype might be specified as either a keyword or a four-digit hexadecimal value from 0x0600-0xFFFF. The currently supported values are: appletalk, arp, Quality of Service (QoS) Commands 474