Netgear M4100-D10-POE CLI Manual - Page 531
show running-config interface, show sysinfo, trapflags
View all Netgear M4100-D10-POE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 531 highlights
ProSafe M4100 and M7100 Managed Switches Note: If you issue the show running-config command from a serial connection, access to the switch through remote connections (such as Telnet) is suspended while the output is being generated and displayed. Note: If you use a text-based configuration file, the show running-config command will only display configured physical interfaces, that is, if any interface only contains the default configuration, that interface will be skipped from the show running-config command output. This is true for any configuration mode that contains nothing but default configuration. That is, the command to enter a particular config mode, followed immediately by its 'exit' command, are both omitted from the show running-config command output (and hence from the startup-config file when the system configuration is saved.) If all the flags in a particular group are enabled, the command displays trapflags all. If some, but not all, of the flags in that group are enabled, the command displays trapflags . Format Mode show running-config [all | ] Privileged EXEC show running-config interface This command shows the current configuration on a particular interface. The interface could be a physical port or a virtual port-like a LAG or VLAN. The output captures how the configuration differs from the factory default value. Format Mode show running-config interface {} | VLAN | LAG } Interface Config show sysinfo This command displays switch information. Format Mode show sysinfo Privileged EXEC Utility Commands 531