Netgear M4100-D10-POE CLI Manual - Page 426
show ipv6 pim neighbor, show ipv6 pim interface, specified interface.
View all Netgear M4100-D10-POE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 426 highlights
ProSafe M4100 and M7100 Managed Switches PIM Mode Dense Data Threshold Rate (Kbps 0 Register Rate-limit (Kbps 0 Interface Interface Mode Operational-Status 0/1 Enabled Non-Operational show ipv6 pim neighbor Use this command to display the PIM neighbor information for all interfaces or for the specified interface. Format Modes show ipv6 pim neighbor [|vlan] • Privileged EXEC • User EXEC Term Interface Neighbor Address Up Time Expiry Time DR Priority Definition Valid slot and port number separated by forward slashes. The IP address of the neighbor on an interface. The time since this neighbor has become active on this interface. The expiry time of the neighbor on this interface. DR Priority configured on this interface (PM-SM only). Example: The following shows example CLI display output for the command. (Switch) #show ipv6 pim neighbor 0/1 Interface Neighbor Address Up Time (hh:mm:ss) Expiry Time (hh:mm:ss) show ipv6 pim interface Use this command to display PIM configuration information for all interfaces or for the specified interface. If no interface is specified, configuration of all interfaces is displayed. Format Modes show ipv6 pim interface [|vlan] • Privileged EXEC • User EXEC Term Mode Interface Definition Active PIM protocol. Interface number. IPv6 Multicast Commands 426