Netgear WAG102 WAG102 Reference Manual - Page 80
Wireless Point-to-Multi-Point Bridge, Repeater
UPC - 606449028799
View all Netgear WAG102 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 80 highlights
ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g) • Wireless Point-to-Multi-Point Bridge. Select this only if this WAG102 is the "Master" for a group of Bridge-mode Wireless Stations. The other Bridge-mode Wireless Stations must be set to Point-to-Point Bridge mode, using the MAC address of this WAG102. They then send all traffic to this "Master", rather than communicate directly with each other. WEP can (and should) be used to protect this traffic. • Repeater. If selected, this wireless access point will operate as a Repeater only, and send all traffic to the remote access point. If selected, you must enter the MAC address (physical address) of the remote access point. The screens used to configure these options are located by selecting Access Point Settings 11a or Access Point Settings 11b/g under Advanced on the main menu (see Figure 4-3 below. Figure 4-3 The screens used to configure these wireless access point modes are shown in Figure 4-3 above, and described in the following sections. 4-4 Advanced Configuration v2.0, September 2006